Original Item: Only One Available. Offered here is a nice service used example of the 3rd Model Pattern 1853 Enfield Rifle Musket, as produced in England with brass butt plate, trigger guard and nose cap. The three steel barrel bands are held on with screw pressure, as typical of the 3rd model. The screws are not recessed, as they would be on the "Baddeley" type bands used on the later 4th model.

The lock is marked  TOWER / 1861 below the cap bolster, and it is marked with a QUEEN'S CROWN to the rear of the hammer. However, there is NO V.R. under the crown. This indicates that this weapon was not intended for a British Military contract but was aimed at the Overseas market, most specifically the United States, who were embroiled in its most terrible Civil War.

As a Confederate destined weapon it should have the right hand side of the butt stamped with a roundel stating "BIRMINGHAM SMALL ARMS TRADE", however this marking is now GONE due to wear. There is however still a faint maker mark on the bottom of the butt stock, however we cannot read it. The barrel bears British Proof Marks, which are still relatively clear. They are the correct Birmingham proof marks, including the CROWN / CROSSED SCEPTERS / BPC "proof" and CROWN / CROSSED SCEPTERS / V "viewed" marks. There is also the CROWN / BP definitive proof, and two 24 markings, indicating "24 bore" or about .579".

A similar Short Rifle edition of this same weapon, dated 1861, appears on the Cover of THE CONFEDERATE ENFIELD by Captain Steven W. Knott, U.S.N. (Ret). with a write up on pages 44 and 45. In addition there is a photograph of the proof marks of this known Confederate Soldier's Rifle on the Title page of the book which are completely identical to those on this weapon. This excellent book states that the Confederate Buying Agents, Josiah Gorgas and Caleb Huse purchased over 350,000 European Rifles between 1861 and 1865, over 250,000 of these were the Percussion Enfield Rifled Muskets and 100,000 were Austrian Percussion arms.

The Union also imported Enfields which were highly prized by Federal soldiers more so than the Union made arms apparently. The Confederacy however contracted for the greater number which in most cases were transported by "BLOCKADE RUNNERS" based in Bermuda. Well documented in the THE CONFEDERATE ENFIELD book.

We found no specific STATE Markings on our rifle, however conditions were often such that little time was available for such niceties upon importation. Also the rifle definitely saw a good amount of use and cleaning, which most likely removed any importation markings that were present. We speculate it probably arrived in 1861-62, having been produced in 1861.

The rifle is in very good service used condition overall, and is mostly complete with the rear sight, and all three barrel bands, though both sling swivels are missing. The ramrod rod is present as well, though it is currently quite difficult to remove from the stock. The lock is fully functional, holding at half cock and firing only at the full cock position. The metalwork shows a lovely mottled oxidized patina, without any major rust, giving it the look of a rifle that was "really there", and wasn't over polished like so many are. There is some powder burn near the cap bolster, but we've definitely seen far worse. The bore still shows clear three groove rifling, though there is definitely some past fouling and oxidation. We usually see these export rifles with bores like stovepipes, so it is definitely better than average.

The stock is in very good original condition with a lovely color. It definitely looks to have been cleaned and possibly arsenal reconditioned over the years, which has unfortunately removed any markings that were stamped into it. There is a repaired split along the grain on the right side, which does not go all the way to the left side.

A very nice example of a P-1853 three band percussion rifle with a possible CSA connection! Ready to display and research!

Specifications (Rifle):-

Year of Manufacture: 1861
Caliber: .58 inches
Ammunition Type: .577 Lead Ball & Powder with Percussion Cap
Barrel Length: 39 inches 
Overall Length: 55 inches
Action: Side Action Percussion Lock
Feed System: Muzzle-Loaded

NOTE: International orders of antique firearms MUST be shipped using UPS WW Services (courier). USPS Priority Mail international will not accept these. International customers should always consult their country's antique gun laws prior to ordering.

IMA considers all of our antique guns as non-firing, inoperable and/or inert. Title 18, U.S. Code, Section 921(a)(16) defines antique firearms as all guns made prior to 1899. This law exempts antique firearms from any form of gun control or special engineering because they are not legally considered firearms. No FFL, C&R or any license is required to possess, transport, sell or trade Antique guns. All rifles and muskets sold by IMA that were manufactured prior to 1899 are considered Antiques by the US BATF (United States Bureau of Alcohol, Tobacco & Firearms). Therefore, all of IMA's Antique guns may be shipped to all US States and most nations around the world.

These antique guns are not sold in "live" condition, and are not tested for the the ability to feed or load any type of cartridge. They are sold as collector's items or as "wall hangers" not for use, and we make no guarantees regarding functionality aside from what is stated in the description. Any attempt at restoring an antique gun to be operational is strongly discouraged and is done so at the risk of the customer. By purchasing an antique gun from IMA you thereby release IMA, its employees and corporate officers from any and all liability associated with use of our Antique guns.

Pre-1899 Manufacture, no licenses required, allowed to ship to almost any deliverable address across the globe. Please note that for international shipping, these MUST be shipped using UPS WW Services. International customers should always consult their country's antique gun laws prior to ordering.