Original Item. Only One Available. This is a great inert 20mm German WWII FLAK 38 round nicely marked on the base and offered in very good condition. The round is approximately 8" in length.

This example is marked on the base eeo 44 2k (Waffenamt). The side of the projectile is marked eds 22 b 43.

A great example, ready for further research and display.

The Flak 30 (Flugabwehrkanone 30) and improved Flak 38 were 20mm anti-aircraft guns used by various German forces throughout World War II. It was not only the primary German light anti-aircraft gun, but by far the most numerously produced German artillery piece throughout the war. It was produced in a variety of models, notably the Flakvierling 38 which combined four Flak 38 autocannons onto a single carriage.

Even as the Flak 30 was entering service, the Luftwaffe and Heer (army) branches of the Wehrmacht had doubts about its effectiveness, given the ever-increasing speeds of low-altitude fighter-bombers and attack aircraft. The Army in particular felt the proper solution was the introduction of the 37 mm caliber weapons they had been developing since the 1920s, which had a rate of fire about the same as the Flak 38, but fired a round with almost eight times the weight. This not only made the rounds deadlier on impact, but their higher energy and ballistic coefficient allowed them to travel much longer distances, allowing the gun to engage targets at longer ranges. This meant it could keep enemy aircraft under fire over longer time spans.

The 20 mm weapons had always had weak development perspectives, often being reconfigured or redesigned just enough to allow the weapons to find use. Indeed, it came as a surprise when Rheinmetall introduced the 2 cm Flakvierling 38, which improved the weapon just enough to make it competitive once again. The term Vierling literally translates to "quadruplet" and refers to the four 20 mm autocannon constituting the design.

The Flakvierling weapon consisted of quad-mounted 2 cm Flak 38 AA guns with collapsing seats, folding handles, and ammunition racks. The mount had a triangular base with a jack at each leg for levelling the gun. The tracker traversed and elevated the mount manually using two handwheels. When raised, the weapon measured 307 cm (10 feet 1 inch) high.