Original British Sterling SMG Mk IV L2A3 Display Gun with Magazine - Serial No S14515
Original Item: Only One Available. This is a very good condition Sterling Mark 4 (L2A3) display gun. You don't see these often and if you do it has generally been adapted for use in a STAR WARS film. This is the most exciting SMG of post WWII years, the British 9mm Sterling MkIV SMG!
This display gun is superbly built from all original post WWII parts then fitted with a solid steel totally non-operational BATF approved display receiver, making it legal to own in the USA. It still has the complete markings mostly visible on the magazine well:
9M/M MK 4 (L2A3)
It was painted with a very nice crinkle black paint, to approximate the powder coating many received while in service. This has unfortunately made the magazine well markings a bit hard to read close to the receiver tube. The underside of the magazine well still has partial patent information visible, which we rarely see!
It has a fully operational folding stock and moveable trigger, which still has a functional selector switch. It even comes complete with a curved Sterling 9mm Magazine (where permitted). The magazine catch is fully functional, and the folding stock properly stows under the front of the gun.
We have not had one of these for quite some time, and it will not last long!
History of the Sterling submachine gun-
The Sterling submachine gun is a British submachine gun. It was trialled with the British Army in 1944-1945 as replacement for the Sten but it did not start to replace the Sten until 1953. It remained in use until 1994, when it was phased out with the introduction of the L85A1 assault rifle.
In 1944 the British General Staff issued a specification for a new submachine gun. It stated that the weapon should not weigh more than six pounds (2.7 kg), should fire 9×19mm Parabellum calibre ammunition, have a rate of fire of no more than 500 rounds per minute and be sufficiently accurate to allow five single shots to be fired into a one foot square target at 100 yards (91 m).
To meet the new requirement, George William Patchett, the chief designer at the Sterling Armaments Company of Dagenham submitted a sample weapon of new design in early 1944. The army quickly recognised its potential (i.e. significantly increased accuracy and reliability when compared to the Sten) and ordered 120 examples for trials. Towards the end of the Second World War, some of these trial samples were used in combat by airborne troops at Arnhem and elsewhere, where it was known as the Patchett submachine gun. Given that the Patchett/Sterling can use straight Sten submachine gun magazines as well as the curved Sterling design, there were no interoperability problems.
After the war, with large numbers of Sten guns in the inventory there was little interest in replacing them with a superior design. However, in 1947 a competitive trial between the Patchett, an Enfield design, a new BSA design and an experimental Australian design was held, with the Sten for comparison. The trial was inconclusive but was followed by further development and more trials. Eventually the Patchett design won and the decision was made in 1951 for the British Army to adopt it. It started to replace the Sten in 1953 as the Sub-Machine Gun L2A1. Its last non-suppressed variation was the L2A3, but the model changes were minimal throughout its development life.
Sterling submachine guns with minor cosmetic alterations were used in the production of the Star Wars movies as blaster rifle props.
Unassigned: Patchett Machine Carbine Mark 1 (trials commenced in 1944)
Unassigned: Patchett Machine Carbine Mark 1 & Folding Bayonet (same as above but with folding bayonet, never accepted)
L2A1: (Patchett Machine Carbine Mark 2) Adopted in 1953.
L2A2: (Sterling Mark 3) Adopted in 1955.
L2A3: (Sterling Mark 4) Adopted in 1956. Last regular version in service with the British Army.
L34A1: Suppressed version (Sterling-Patchett Mark 5). Held in reserve by the British Army.
- This product is not available for international shipping.
- This item is completely legal within the USA. International Military Antiques, Inc observes all Federal, State and Local laws. Everything for sale on ima-usa.com is completely legal to own, trade, transport and sell within the United States of America. Every display machinegun and machine gun parts set and gun sold by IMA, Inc is engineered to be inoperable according to guidelines provided by the US Bureau of Alcohol, Tobacco, Firearms and Explosives (BATF). Please note that the requirements for each display gun are decided on a per case basis by the BATF, and may require deactivation of omission of some internal components. For more information on this display gun, please contact us. Not available for Export.
High Capacity Magazine Laws & Restrictions Due to State & Federal law we do not ship magazines that exceed the following capacities to the following locations: California - 10 round maximum for all magazines. Hawaii - 10 round maximum for all handgun magazines. Maryland - 20 round maximum for all magazines. Massachusetts - over 10 rounds. New Jersey - 15 round maximum for semi-automatic firearms only. International- No gun magazines can be exported from the USA.
- Not eligible for payment with Paypal or Amazon